MIL-DTL-46550D(AR)
DEPARTMENT OF DEFENSE STANDARDS
MIL-STD-1168
-
Ammunition Lot Numbering and Ammunition Data
Card
MIL-STD-1916
-
DOD Preferred Method for Acceptance of Product
(Copies of these documents are available online at https://assist.daps.dla.mil/quicksearch/ or
from the Standardization Document Order Desk, 700 Robbins Avenue Bldg. 4D, Philadelphia,
PA 19111-5-94.)
2.2.2 Other Government documents, drawings and publications. The following other
Government documents, drawings and publications form a part of this document to the extent
specified herein. Unless otherwise specified, the issues of these documents are those cited in the
solicitation (see 6.2).
ARDEC Drawings
8858382
-
Charge, Demolition, Shaped, 40 lb., M3A1, Metal Parts
Assembly
8858394
-
Charge, Demolition, Shaped, 40 lb., M3A1, Closing Cap
Assembly
8858401
-
Stand-off Frame Assembly
(Copies of these drawings are available from US Army ARDEC, AMSRD-AAR-AIS-TD,
Picatinny, NJ 07806-5000, or online from Drawing-Request@us.army.mil.)
2.3 Order of precedence. In the event of a conflict between the text of this document and
the references cited herein, the text of this document takes precedence. Nothing in this document,
however, supercedes applicable laws and regulations unless a specific exemption has been
obtained.
3. REQUIREMENTS
3.1 First Article. When specified, a sample shall be subjected to first article inspection
in accordance with 4.2.
3.2 Material. Materials, parts and assemblies shall comply with all requirements
specified on the applicable drawings and referenced specifications.
3.3 Assemblies. The assemblies shall comply with all requirements specified on
applicable drawings and with all requirements specified in the applicable specifications.
3.4 Welds of stand-off frame assembly. The weld of each leg of the stand-off frame
assembly shall withstand a free fall of not less than four (4) feet onto a steel or concrete surface,
with the leg striking the surface at approximately thirty (30) degrees from a vertical position,
2
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business