MIL-DTL-45468F(AR)
C Tree Road, Bldg. 35, McAlester, OK 74501.)
2.3 Non-Government publications. The following documents form a part of this
document to the extent specified herein.
ASTM INTERNATIONAL
ASTM B 749
-
Standard Specification for Lead and Alloy Strip, Sheet, and
Plate Products
(Copies of ASTM standards may be ordered online at https://www.astm.org/ or from ASTM
International, 100 Barr Harbor Drive, Conshohocken, PA 19428-2959.)
2.4 Order of precedence. In the event of a conflict between the text of this document and
the references cited herein, the text of this document takes precedence. Nothing in this
document, however, supercedes applicable laws and regulations unless a specific exemption has
been obtained.
3. REQUIREMENTS
3.1 Required inspections.
3.1.1 First article. When specified, a sample shall be subjected to first article inspection
in accordance with 4.2.
3.1.2 Conformance. A sample shall be subjected to conformance inspection in
accordance with 4.3.
3.2 Materials and parts. Materials and parts shall be in accordance with the drawings
and specifications cited.
3.3 Assemblies. The assemblies shall comply with all requirements specified on
8830971 and 8830972.
3.4 Moisture content of the lead azide. The moisture content of the lead azide at the
loading station, at the time of loading the blasting cap assemblies, shall be not greater than 0.50
percent.
3.5 Pull test of the lead wires. Lead wires shall not be separated from the blasting cap
when a pull force of 5 pounds (lbf) is exerted on each individual lead wire while the blasting cap
is held stationary.
3.6 Resistance of bridge wire and wire leads. Resistance of blasting cap, including
bridge wire and wire leads, shall be not greater than 1.76 ohms and not less than 1.44 ohms.
3
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business